Recall
any program that has already been set
up for a product type and target weight
similar to the new product and target
weight.
Determine the difference between the
existing (pre-programmed) target weight
and the new target weight.
Press
to add value to the existing target
weight, or
to subtract value from the existing
target weight.
Now, press
followed by the amount you wish to add/subtract.
Store
the new program, using command
followed
by the two digit memory location you
wish to store it in.*
EXAMPLE
Suppose program #02 has already been
set up for 2.00 oz. of rice, and let's
say you have a new requirement for 1.75
oz. of dry beans:
You would recall program #02, press
command
to subtract, then
followed by "0025" (the difference
between 2.00 oz. and 1.75 oz.).
Note: The display does
not have a decimal point. For 2 oz,
the display would actually read "0200"
in this example. Keep this in mind when
adding or subtracting.
That's it! You're done. The controller
makes the other adjustments, automatically.
*See "Quick Check Guide" for
more complete listing of command and
set-up procedures and "Supervisor
Codes" (paragraph C) if override
command is required.
to add value to the existing target
weight, or 
to subtract value from the existing
target weight. 
followed by the amount you wish to add/subtract.
